US SUPREME COURT DECISIONS

BANTZ V. FRANTZ, 105 U. S. 160 (1881)

Subscribe to Cases that cite 105 U. S. 160

U.S. Supreme Court

Bantz v. Frantz, 105 U.S. 160 (1881)

Bantz v. Frantz

105 U.S. 160

Syllabus

1. Reissued letters patent No. 4731, granted Feb. 6, 1872, to Gideon Bantz for an improvement in boiler furnaces for burning wet fuel, are void inasmuch as the specification and claim attached to the original letters No. 26,616, which bear date June 22, 1858, were confined to a combination therein described, whilst the reissued letters cover the several elements of that combination as distinct inventions.

2. If the first specification was defective in not asserting a separate claim for each device, the right of the patentee to make the requisite correction was forfeited by his delay and laches. Miller v. Brass Company, 104 U. S. 350, cited upon this point and reaffirmed.

On June 22, 1858, there was issued to Gideon Bantz, the appellant, who was complainant in the court below, an original patent of that date "for an improvement in furnaces for heating steam boilers." On Feb. 6, 1872, Bantz obtained a reissue, and on June 22, 1872, an extension for seven years of his reissued patent.

The bill in this case was filed by him on May 4, 1876, to restrain infringement by the defendant, David Frantz, of the extended reissue.

The answer denied the novelty and utility of the invention, denied infringement, and asserted the invalidity of the reissue.

The Circuit Court dismissed the bill, and the case is brought here by the complainant.

The specification of the original patent declared:

"The object of this invention is the more perfect combustion of tan, sawdust, bagasse, and all other kinds of refuse fuel in a wet or dry state, as well as of wood or coal. It is, however, with particular advantage to the burning of wet fuels. My invention consists in the arrangement embracing, for united use in the manner and for the purposes hereinafter specified, the following features, to-wit:"

"First, two or more arched fire chambers, with throats of less area than their capacity; second, an auxiliary combustion reservoir or chamber, with cima-reversa shaped bottom and side draft door; third, a series of reverberatory chambers, with side draft doors and

Page 105 U. S. 161

passages at top for communication with each other; and, fourth, a diving or direct flue leading into the chimney or smokestack."

"To enable others skilled in the art to make and use my invention, I will proceed to describe its construction and operation."

"A A are two arched fire chambers, arranged side by side furnished with grates a a, having ash pit B B provided below the said grates. These fire chambers are not placed below the boiler H, but directly in front thereof, and longitudinally therewith. They may, however, be placed at one side of the boiler or at any angle to it. Each is provided with the usual door b, but these are only used for lighting the fires, and the ash pits are provided with doors c to regulate the supply of air through the grates, and permit the cleaning out of ashes. On the top of each chamber there are feeders d d for supplying the fuel, but as these feeders are the same as used in other furnaces, no particular description of them is necessary. The fire chambers are covered with a flat floor built over the arches, that the fuel may be wheeled to the feeders in barrows, or brought in any other convenient manner. At the rear end of each fire chamber there is a throat-like aperture e communicating with what I term the reservoir C, which is built of brick, lined with firebrick, under the front portion of the boiler, and which has a concave bottom in and convex back n, which are formed by a cima-reversa shaped plate. By having the bottom and back of the reservoir formed by a cima-reversa shaped plate, the throat e is not partially closed up, as it would be if the plate was straight and set inclined, and, beside this, the heated products of combustion are made to hug the bottom of the boiler, and as the draft is at this point, the perfect combustion of partially ignited gases is insured. The convex back of the reservoir terminates in and serves as a bridge wall, and has a concave top so formed as to leave a space, o, of but three or four inches between it and the boiler."

"The purpose of the reservoir will be presently explained. In rear of the bridge wall f there is a series of reverberatory chambers D D D, two, three, or more, one behind the other, the series extending nearly as far as the rear end of the boiler, and the said chambers being severally separated by bridge walls g g, and each chamber being provided with one or more doors h in either or both sides, for the purpose of admitting air in sufficient quantities either to complete the combustion of the gases from the fire chambers or to check the draft. The reservoir is furnished with a door h1 for a similar purpose as those h h in the reverberatory chamber. At the rear of the hindmost reverberatory chamber there is a wall g1, like

Page 105 U. S. 162

g g, behind which there is a diving or drop flue E leading to the chimney."

"The operation of the furnace is as follows: the gaseous products of the combustion in the fire chamber A A escape by the throats e e into the reservoir C, where they mingle together, and the combustible portion thereof becomes ignited, and where their heat acts upon the boiler, and from whence they pass into one after another of the reverberatory chambers, in each of which a portion of their heat is abstracted by contact with a portion of the boiler, and finally they descend the flue E to the chimney. The effect of the principal portion of my improvement, which consists in the employment of the reservoir C, connected with the fire chambers by the throats e e, of much smaller transverse area than the fire chamber, is that the products of combustion and heat are prevented leaving the fire chamber too rapidly, and the said chambers are consequently caused to be heated to an intense degree, and a very nearly perfect combustion of the fuel is obtained therein, and when the gaseous products of combustion leave the fire chambers by the said throats and arrive in the reservoir C, the side walls and curved bottom and back of which are kept at a white heat, the still combustible portion of the gaseous products is ignited under the boiler."

The claim was thus stated:

"What I claim as my invention, and desire to secure by letters patent, is: the arrangement of fire chambers A A, contracted throats e e, auxiliary combustion reservoir C, with the cima-reversa bridge plate in n, and the door h1, reverberatory chambers D D, with doors h h, and the diving or direct flue E, substantially as and for the purposes set forth."

The description of the invention in the specification of the reissued patent is substantially the same as that in the specification of the original patent. The drawings are identical. In the reissue the invention is called "a new and useful improvement in furnaces for burning wet fuel." The claim is thus set forth:

"I do not claim a furnace for burning wet fuel, broadly, nor the use of a series of fire chambers connecting with the common flue, arranged between the furnace and the boiler, as I am well aware that this had been done before. "

Page 105 U. S. 163

"Having described my invention, I claim:"

"1. In a furnace for burning wet fuels, having two or more single fire chambers not arranged under the boiler, the combustion chamber or reservoir C, arranged above the top of said fire chambers, and located directly under the front end of the boiler, essentially as described."

"2. The cima-reversa bottom in n of the combustion chamber or reservoir C, in combination with the narrow throats e of the separate fire chambers, and the narrow exit flue o of the bridge walls f, for the purpose essentially as described."

"In combination with the combustion chamber or reservoir C, arranged and located as described, I claim the side door or doors h1 for the admission of atmospheric air, for the purpose described."

"4. In combination with a series of fire chambers A and the combustion chamber or reservoir C, located and arranged directly beneath the front end of the boiler, and above the Crown of said fire chamber, I claim a series of reverberatory chambers D, provided with side doors h and a diving flue E at the rear end of the boiler, to hold the heat beneath the same throughout its entire length, and to arrest and deaden the sparks as described."

"5. In a furnace for burning wet fuels in which the fire chambers are not arranged under the boiler, I claim the arrangement of the boiler upon the rear wall of the furnace and the rear wall of the diving flue E for the purpose of obtaining the full advantage of the heat of the walls of the furnace, and of the diving flue, as described."

"6. In a furnace for burning wet fuels, having a flat top, and supplied through openings therein, I claim the dead chambers, arranged between the floor and the arches of the fire chambers, for the purpose of maintaining the top of the furnace cool for the workingmen as described."



























chanrobles.com



ChanRobles Legal Resources:

ChanRobles On-Line Bar Review

ChanRobles Internet Bar Review : www.chanroblesbar.com

ChanRobles MCLE On-line

ChanRobles Lawnet Inc. - ChanRobles MCLE On-line : www.chanroblesmcleonline.com